The world of hybrid drive — Everything you need to know

By Christopher A. Sawyer
The Virtua
l Driver

(December 15, 2013) When reduced to its basics, there are but four hybrid powertrain types. They are: 1) Micro hybrids; 2) Parallel hybrids; 3) Power-split, Two-mode or Series-parallel hybrids;
and 4) Series hybrids. Series hybrids are more commonly known as an E-REV, or Extended-Range Electric Vehicle, and is best represented by the Chevy Volt/Cadillac ELR.

There also are “full” or “mild” hybrids. Full hybrids are capable of propelling the vehicle on just the engine, just the electric motor or on a combination of both. Mild hybrids offer start-stop capability, perhaps with a level of power assist to the combustion engine and regenerative braking. They can’t provide full-EV propulsion.

Micro Hybrids

Micro hybrids are the first step between conventional internal combustion-powered vehicles and true hybrids. They add start-stop capability, shutting down the engine when the vehicle has come to a complete stop, and electrical load is low enough to allow demand to be met without need for the alternator to recharge the battery.

It provides its benefits by eliminating idling, and quickly spinning the engine up once the brake pedal is released; allowing the driver to accelerate away normally. Only starting to make its presence felt in North America due to the fact that the official EPA drive cycle doesn’t have much time where the test vehicle is stationary, this option makes little difference in the mileage rating.

Nevertheless, it is available across the BMW and Porsche lineups, as well as on the Kia Rio, and Ford will expand its availability from just the 1.6-liter Fusion to all Ford cars. Studies expect eight million U.S. vehicles by 2017 to use the technology, thanks to the new CAFE standards. It’s use also will expand as automakers upgrade electrical systems and batteries to allow engines to be shut off while the vehicle is coasting.

Parallel Hybrids

The parallel hybrid couples a combustion engine, an electric motor and electronically controlled clutches. Honda’s Insight uses a parallel hybrid drivetrain, placing a 10 kW brushless electric motor between the 1.3-liter inline four-cylinder engine and CVT transmission. Because they apply power to the same shaft, the speeds of the two power sources are equal, and the torque values add up, with the electric motor adding or subtracting torque as necessary.

Honda claims it is smaller and both less expensive and complex than power-split systems, while offering some of their mileage advantages. In addition to the Insight, Honda offers this technology on the Civic, CR-Z and Acura ILX.

The Belt Alternator Starter mild hybrid is another form of parallel hybrid that uses a battery and motor-generator unit that replaces the conventional alternator. It can provide modest power upon launch or under acceleration, and recover some energy through regenerative braking. The advantages of this technology are many: it doesn’t require any significant modifications to the vehicle, can be produced on the same line as a non-BAS vehicles), and is one of the least expensive hybrid systems available.

The latest version of this technology at GM is called eAssist, and uses a 15 kW motor-generator in conjunction with a 115-volt lithium-ion battery. This technology currently is available on the Buick Regal and LaCrosse, and Chevy Malibu.

Power-split Hybrids

Power-split hybrids are the ones most people think of, thanks to the success of Toyota’s Prius. As with the pure parallel system, there is an internal combustion engine and an electric motor-generator. However, power is shared between the two, and the wheels are driven through a planetary gearset that can allow either power source to provide 0% to 100% of the vehicle’s power need.

Toyota’s Hybrid Synergy Drive uses a second electric motor, mounted on the output shaft, and it works with the planetary gearset and primary motor-generator to create a CVT transmission equivalent. The term “power-split” refers to the fact that these hybrids have power paths to the wheels that can be either mechanical or electrical, and that the power demanded by the driver is decoupled from the power supplied by the engine.



The engine most often used with this hybrid system is an Atkinson-cycle gasoline unit. Unlike the typical Otto-cycle engine, it has less power density and low-rpm torque, but higher efficiency at speed. The electric drive motor provides full torque the minute it begins to turn, filling in the engine’s low-speed torque gap. This allows the Atkinson-cycle gas engine’s efficiency to be preserved. When more acceleration is needed, the two combine forces to provide the necessary output.

Every Toyota/Lexus hybrid uses a power-split hybrid, as do the units in the Ford Fusion and C-Max, Lincoln MKZ, Nissan Altima, Infiniti M35h, VW Jetta and Touareg, BMW ActiveHybrid 5 and 7, Mercedes S400, Porsche Cayenne and Panamera, Hyundai Sonata, Kia Optima, Audi Q5 Hybrid, Honda Accord, and McLaren P1 among others.

The two-mode hybrid that has been used by GM, BMW and Mercedes in some trucks and SUVs, on the other hand, adds two planetary gear sets and four clutches to allow these vehicles to operate in full-electric, full-combustion engine, or blended (electric and combustion engine) modes.

The unique towing and payload requirements of light trucks spurred GM to adapt its Allison two-mode bus transmission for use in light trucks. And though it delivers up to 25% greater efficiency than a non-hybrid truck, the cost per unit is greater than the high-torque eight-speed planetary automatic transmission BMW has switched to. Mercedes now relies on seven-speed transmissions and diesel models to replace its ML-Class hybrid.

Nevertheless, the Allison design blends electric and combustion power to cope with both low- and high-speed operation, while allowing the use of smaller motors than found on single-mode systems. It’s available on the Chevy Silverado, Tahoe and Suburban; GMC Sierra and Yukon; and Cadillac Escalade, though whether it will make the transition to the new versions of these vehicles is anybody’s guess. GM is rumored to have a light-duty truck diesel waiting in the wings.

Series Hybrids

Electric motors have high power-to-weight ratios and, when sized properly, can provide sufficient torque over a wide speed range to replace a multi-speed transmission with a simple single-speed unit. At their most basic, series hybrids use the combustion engine to drive a starter-generator that provides power to the electric motor(s). Adding plug-in capability allows the storage batteries to be charged off the electrical grid, providing for some level of gas- or diesel-free travel.

When this limit is reached, the combustion engine engages to drive the starter-generator in order to charge the battery pack and drive the wheels. Except for the large battery pack that allows the car to be driven with the engine off, this layout resembles that of a modern diesel-electric locomotive or of the Lohner-Porsche Mixte car of 1901-1905.

Chevy’s Volt has four operating modes and can function as a battery electric vehicle, series hybrid and power-split hybrid. As a single-motor electric, it runs on battery power, producing a maximum output of 111 kW. When the battery is depleted, and speeds are not too high, it goes into single-motor extended operation, and uses the second electric motor as a generator for battery charging. In this mode, the main traction motor can provide full output for short bursts, but not for sustained driving.

Dual-motor electric mode engages the second motor and planetary gearset to reduce the speed of the primary electric motor at higher speeds in order to improve efficiency and mileage without increasing output. This can move to an extended range mode where the two motors are engaged, but the gasoline engine helps drive the wheels through the planetary gearset. Under these conditions, the powertrain has the same output as in dual-range, but draws less power from the batteries in order to extend the vehicle’s range.

And while the Chevy Volt/Cadillac ELR and the late Fisker Karma are the only plug-in series hybrid vehicles on the market, they probably won’t be the last. As legislation pushes automakers toward low CO2/high fuel economy solutions, series hybrids may become more plentiful. Look for automakers to follow BMW’s lead with its iSeries vehicles and add small range extender engines to electric vehicle drivetrains in order to eliminate range anxiety, increase sales and amplify mileage credits.

By designing this engine to operate at high efficiency during normal and maximum charge events with a minimal NVH signature, it removes the inefficiencies of the power-split hybrid motors, which have to run at a wide range of speeds, and opens the possibility of turning its production and supply over to third parties specializing in this technology.

The Virtual Driver